First thought that comes to mind: it may be stopping because of the feature
which pauses the screen output after 8 lines of consecutive output – try
Label-F1-Label to toggle ‘Sc L’ to ‘Sc S’ to disable this before redirecting
the console?
I’m glad to see this post because I honestly had been thinking a while back
that “I wish there was a way to use a ps/2 keyboard with my MVT100 board as a
full-blown terminal” but didn’t try anything because I’m not familiar enough
with CP/M to know how to redirect the console like that. What baud rate does
it end up using when you do this?
jim
From: M100 <[email protected]> On Behalf Of Tom Hoppe
Sent: Tuesday, November 16, 2021 10:50
To: [email protected]
Subject: [M100] Re-directing CP/M console to serial port in REXCPM
CAUTION External Sender: Do not click links or open attachments unless you
recognize the sender and know the content is safe.
I am trying to re-direct the REXCPM console to the M100 serial port but only
having limited success. I am using 'stat con:=uc1:' to do the re-direct. It
seems to work for a minute, then stops. I am using minicom in Linux and it
works reliably using the REXCPM 'F3 toggle' feature to re-direct only the
screen output (19200 8N1). Has anyone else tried doing this successfully?
Tom Hoppe
