I think Philip Avery is probably best to comment on to what degree that is supported. It is a good question.
On Tue, Nov 16, 2021 at 2:21 PM Jim Anderson <[email protected]> wrote: > First thought that comes to mind: it may be stopping because of the > feature which pauses the screen output after 8 lines of consecutive output > – try Label-F1-Label to toggle ‘Sc L’ to ‘Sc S’ to disable this before > redirecting the console? > > > > I’m glad to see this post because I honestly had been thinking a while > back that “I wish there was a way to use a ps/2 keyboard with my MVT100 > board as a full-blown terminal” but didn’t try anything because I’m not > familiar enough with CP/M to know how to redirect the console like that. > What baud rate does it end up using when you do this? > > > > > > > > > > > > > > > > jim > > > > *From:* M100 <[email protected]> *On Behalf Of *Tom Hoppe > *Sent:* Tuesday, November 16, 2021 10:50 > *To:* [email protected] > *Subject:* [M100] Re-directing CP/M console to serial port in REXCPM > > > > *CAUTION External Sender:* Do not click links or open attachments unless > you recognize the sender and know the content is safe. > > > > I am trying to re-direct the REXCPM console to the M100 serial port but > only having limited success. I am using 'stat con:=uc1:' to do the > re-direct. It seems to work for a minute, then stops. I am using minicom in > Linux and it works reliably using the REXCPM 'F3 toggle' feature to > re-direct only the screen output (19200 8N1). Has anyone else tried doing > this successfully? > > > > Tom Hoppe > > > >
