Are you using the correct bootstrap? (Pdd 1 vs pdd 2) I made a video a few years ago showing various failure modes if that helps.
https://youtu.be/p4q6pqPSaCU On Mon, Nov 14, 2022, 07:27 Stephen Adolph <[email protected]> wrote: > hi, just a few questions- > > Do you hear any activity at all, like the disk spinning? > Any LED activity at all? > When you toggle power on/off, does the LED flicker once? > Are you using battery or external power? Would be good to confirm the > internal power supply is getting power and working correctly. > > steve > > > > > > On Sun, Nov 13, 2022 at 11:13 PM Spencer <[email protected]> wrote: > >> Hello. >> >> Received a drive from ebay yesterday and it needed some fixing, wouldn't >> take in a floppy (fixed) but kept getting a "Drive not Ready" after I >> tested it again. So I popped the hood again and the belt was melted. I >> cleaned the belt wheels and put in a new belt; hoped this fixed it but >> nope. I ran the IPL from T200 memory and ran the floppy command, but keep >> getting the same error. I'll check the data ribbon again tomorrow to make >> sure I plugged it in fully, but other than that does anyone have any ideas >> of anything else I can check to fix this error? >> >> Thanks, >> Spencer. >> >
