Not sure if the TPDD2 model has dip switches, but perhaps they're in the wrong setting?
On Mon, Nov 14, 2022 at 8:34 AM Josh Malone <[email protected]> wrote: > Are you using the correct bootstrap? (Pdd 1 vs pdd 2) > > I made a video a few years ago showing various failure modes if that helps. > > https://youtu.be/p4q6pqPSaCU > > On Mon, Nov 14, 2022, 07:27 Stephen Adolph <[email protected]> wrote: > >> hi, just a few questions- >> >> Do you hear any activity at all, like the disk spinning? >> Any LED activity at all? >> When you toggle power on/off, does the LED flicker once? >> Are you using battery or external power? Would be good to confirm the >> internal power supply is getting power and working correctly. >> >> steve >> >> >> >> >> >> On Sun, Nov 13, 2022 at 11:13 PM Spencer <[email protected]> wrote: >> >>> Hello. >>> >>> Received a drive from ebay yesterday and it needed some fixing, wouldn't >>> take in a floppy (fixed) but kept getting a "Drive not Ready" after I >>> tested it again. So I popped the hood again and the belt was melted. I >>> cleaned the belt wheels and put in a new belt; hoped this fixed it but >>> nope. I ran the IPL from T200 memory and ran the floppy command, but keep >>> getting the same error. I'll check the data ribbon again tomorrow to make >>> sure I plugged it in fully, but other than that does anyone have any ideas >>> of anything else I can check to fix this error? >>> >>> Thanks, >>> Spencer. >>> >>
