At first glance I didn't see any, but could be. I usually fix the obvious first then go back in if necessary - like doctors. Ha. I've got the manual but not a service guide. Thanks.
Sent from Yahoo Mail on Android On Mon, Nov 14, 2022 at 11:42 AM, Charlie Hoey<[email protected]> wrote: Not sure if the TPDD2 model has dip switches, but perhaps they're in the wrong setting? On Mon, Nov 14, 2022 at 8:34 AM Josh Malone <[email protected]> wrote: Are you using the correct bootstrap? (Pdd 1 vs pdd 2) I made a video a few years ago showing various failure modes if that helps. https://youtu.be/p4q6pqPSaCU On Mon, Nov 14, 2022, 07:27 Stephen Adolph <[email protected]> wrote: hi, just a few questions- Do you hear any activity at all, like the disk spinning?Any LED activity at all? When you toggle power on/off, does the LED flicker once?Are you using battery or external power? Would be good to confirm the internal power supply is getting power and working correctly. steve On Sun, Nov 13, 2022 at 11:13 PM Spencer <[email protected]> wrote: Hello. Received a drive from ebay yesterday and it needed some fixing, wouldn't take in a floppy (fixed) but kept getting a "Drive not Ready" after I tested it again. So I popped the hood again and the belt was melted. I cleaned the belt wheels and put in a new belt; hoped this fixed it but nope. I ran the IPL from T200 memory and ran the floppy command, but keep getting the same error. I'll check the data ribbon again tomorrow to make sure I plugged it in fully, but other than that does anyone have any ideas of anything else I can check to fix this error? Thanks,Spencer.
