Ok i will give it a try, the setup was copied from my BeBoPr++ board as far as far as home and offsets speeds exc,,,
Thanks gary On Saturday, January 6, 2018 at 8:42:16 PM UTC-5, gary wrote: > I just connected a BBB and Cramps board to my delta printer, but i have > been having homing problem > I have optic switches installed if i go into the hal configuration when > machinekit it booted, and then to the show window with xmax ymax and zmax > displayed then when axis's are off the switches there red, and when i > trigger the switches they turn yellow > So i assume the switches are working and being read by the software. > > But when i do home all the motors they move up to the switches in the > correct direction but never stop just keeps running into the optic > end stops and i have to power down.. > > any suggestions? > > Thanks gary > -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
