Guess i am not getting the setp lineardeltakins.j{X}off 0.1 command i
always get an error no pin or along these lines
I went down to x-86.60 y-50.00 z0 and if i am correct that's 100mm radius i
was able to step down below 0 to -7 and that was good for a slight paper
drag
do i need to add 7 to the home offset in the config ? or change the
home value ?.. seeing i can't seem to get the halcmd to work for me, I'm
sure i doing something stupid..
Thanks gary
On Saturday, January 6, 2018 at 8:42:16 PM UTC-5, gary wrote:
> I just connected a BBB and Cramps board to my delta printer, but i have
> been having homing problem
> I have optic switches installed if i go into the hal configuration when
> machinekit it booted, and then to the show window with xmax ymax and zmax
> displayed then when axis's are off the switches there red, and when i
> trigger the switches they turn yellow
> So i assume the switches are working and being read by the software.
>
> But when i do home all the motors they move up to the switches in the
> correct direction but never stop just keeps running into the optic
> end stops and i have to power down..
>
> any suggestions?
>
> Thanks gary
>
--
website: http://www.machinekit.io blog: http://blog.machinekit.io github:
https://github.com/machinekit
---
You received this message because you are subscribed to the Google Groups
"Machinekit" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
Visit this group at https://groups.google.com/group/machinekit.
For more options, visit https://groups.google.com/d/optout.
