I started on Machinekit Nov 21 the day I found it. Used "Getting Started" on your website for installing. Fresh downloads installs of debian stretch for every install of Machinekit using the terminal. Only Machinekit rt-reempt for stretch. The systems have been both P4 64bit and two amd64 4core. On the P4 the linuxcnc.log and terminal output was the same as the one posted here. I will download and install again and attach the files asap. On the amd64 4core I think the problem is that it's not using re-reempt but posix. One post I read said to try flavor, in /usr /libexec/linuxcnc to find out if re-reempt is installed, but all I get is command not found.Same result for 'sudo make setuid'. Because of this maybe the website install is not complete. Tonight I did a fresh download/install of debian stretch and machinekit rt-reempt on an amd64 4core system with the same results as the other amd64 4core. I will run it again and attach the files. I also read that the video card drivers can effect Machinekit. Is it the drivers or the hardware? I booted the P4 on the Linuxcnc drive and ran it and moved around the axis and loaded/ran a large file with no problem. The P4 has been running my plasma table for at least 4 years perfectly so it's solid.
I want this to work... need it... -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
