> > *I* am not using vision for anything at the moment, so I'm assuming > you're asking the original poster. I'm not sure what they have > planned for vision, but I'd be interested in hearing more details > about it as well. >
I did ask him, The answer was a little confusing. They use vision to measure the bamboo then put this information into a model in Fusion 360 and then output standard g-code to drive the mill. So the vision task is complete before the g-code is written and they don't run the mill and the vision at the same time. The confusing part is that if they are running Fusion 360, they have a high-end PC or Mac available. If it can run Fusion, it can run any vision software they would need. > -- > Charles Steinkuehler > [email protected] > > -- > website: http://www.machinekit.io blog: http://blog.machinekit.io github: > https://github.com/machinekit > --- > You received this message because you are subscribed to the Google Groups > "Machinekit" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > Visit this group at https://groups.google.com/group/machinekit. > For more options, visit https://groups.google.com/d/optout. > -- Chris Albertson Redondo Beach, California -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
