#370: Problem during the boot: "wifi%d: unable to attach hardware: 'Hardware
revision not supported' (HAL status 13)"
---------------------------------+------------------------------------------
Reporter: [EMAIL PROTECTED] | Owner: mrenzmann
Type: defect | Status: assigned
Priority: major | Milestone: version 0.9.x - progressive
release candidate phase
Component: madwifi: other | Version: trunk
Resolution: | Keywords: Hardware revision not
supported (HAL status 13)
Patch_attached: 0 |
---------------------------------+------------------------------------------
Comment (by [EMAIL PROTECTED]):
Well, here how I resolved this problem:
I got an Acer Aspire 3502WLCi (sort of economic series) and there is
a led for the wifi that is always ON. Lately I discovered this led is also
a button :oP so no matter if the light is ON, I've got to push that button
once to wake-up the wifi chip and then "modprobe ath_pci"
The problem was also that the key wasn't mapped so I got to use
"setkeycodes"
to make it known, and now I'm trying to automatize the procedure using
the "hotkeys" daemon.
I hope you undestand my bad english,
cheers
Fabio
--
Ticket URL: <http://madwifi.org/ticket/370>
MadWifi <http://madwifi.org/>
Multiband Atheros Driver for Wireless Fidelity
_______________________________________________
Madwifi-tickets mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/madwifi-tickets
