Yes, we have had this same problem. It goes the other way, too: when we finally
convince
it to print 5 copies, then we change print settings back to 1 page, we still get 5.
mdb
Tony Shepherd wrote:
>
> If I choose to print more than 1 copy of a layout and change the number
> of copies in the print dialog box to say 5, I still only get one printed
> copy! This has only happened since upgrading to MI 5.5, and I have even
> reinstalled the plotter drivers. Sometime (but not always) I also get
> the plotter counting down to zero (when plot nesting is turned on) then
> it just sits there on zero and wont start, with the receiving data
> light on.
> Has anybody else had this?
> I am using NT 4.0 and HP DesignJet 750C.
> I am considering removing 5.5 and reinstalling V5.0 as printing seemed
> to work.
> Cheers
> Tony
>
> - - - - - - - - - - - - - - - - - - - - - - - - - - - -
> Tony Shepherd, GIS / IT Support
> Gore District Council, Gore, New Zealand
> Gore,The Brown Trout Capital
> .. .. .. .. check out or sites! .. .. .. ..
> .. . www.mataura.com . ..
> .. . www.goredc.govt.nz . ..
> - - - - - - - - - - - - - - - - - - - - - - - - - - -
>
> ----------------------------------------------------------------------
> To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
> "unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
--
------------------------------------
Marty DeBenedictis
Community Mapping Assistance Project - NYPIRG
http://www.cmap.nypirg.org
[EMAIL PROTECTED]
------------------------------------
----------------------------------------------------------------------
To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
"unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
