1. Export the file to a MIF
2. Alter the line begining "coordsys" to give the correct system /
projection
3. Import your new MIF
Regards
Russ
----- Original Message -----
From: Tim Warman <[EMAIL PROTECTED]>
To: Mapinfo-L (E-mail) <[EMAIL PROTECTED]>
Sent: Thursday, September 02, 1999 10:39 AM
Subject: MI changing the projection of a table
> Having just digitised a number of fault lines in the wrong projection (UTM
> NAD27, should have been State Plane feet), I was wondering if there is a
> way to manually change the projection header of a table without changing
> the absolute values of the data, ie. without translating the data into the
> new projection.
>
> This should allow me to avoid having to re-digitise the fault lines (I
> hope), and I've done the same type of thing with ERMapper files without
any
> trouble.
>
> Cheers,
> Tim
>
> ________________________________________
> Tim Warman
> Geologist & GIS Specialist
> Richard C. Slade & Associates, Consulting Groundwater Geologists
> North Hollywood, CA 91606
> (818) 506-0418
>
> ----------------------------------------------------------------------
> To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
> "unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
>
----------------------------------------------------------------------
To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
"unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
