Hi all
I would like to know from the list if anyone has had the need and as such
found a solution to the problem of combining Polylines, but only between
intersections. I have a need to combine data with no attributes but only
between intersections.
any help would be greatly appreciated
regards
Mark Pollard
Senior Consultant Information Services
DRYDEN TECHNOLOGIES
Ph: 61 (2) 9542-2808
Fax: 61 (2) 9542-2806
Web: www.drydentech.com
The information contained in this email communication may be confidential.
You should only read, disclose, re-transmit, copy, distribute, act in
reliance on or commercialise the information if you are authorised to do so.
If you are not the intended recipient of this email communication, please
notify us immediately by email to [EMAIL PROTECTED] or reply by email
direct to the sender and then destroy any electronic or paper copy of this
message. Any views expressed in this email communication are those of the
individual sender, except where the sender specifically states them to be
the views of a member of the Dryden Technologies. The Dryden Technologies
does not represent, warrant or guarantee neither that the integrity of this
communication has been maintained nor that the communication is free of
errors, virus or interference.
_______________________________________________________________________
List hosting provided by Directions Magazine | www.directionsmag.com |
To unsubscribe, send e-mail to [EMAIL PROTECTED] and
put "unsubscribe MapInfo-L" in the message body.
