Thanks for respond, So I should define new measurments for my case (118) like what they did in example test_se_14bus?
Thanks again, On Wed, Jan 11, 2012 at 1:54 PM, Arash Alimardani <[email protected] > wrote: > All right. First of all, that code is enhanced in the new version: 4.1. > The modified code is in "se" folder. > Secondly, you need to define the measurements locations and types and the > measured data as input values in the new generic code. It works very well > as long as your network is observable. > > > Regards > > > On Wed, Jan 11, 2012 at 7:42 AM, morteza keshavarz < > [email protected]> wrote: > >> Yes I do get answer with just runing runse('case14') with plots or other >> cases but ('case118') doesnt work and gives error. the matpower is 4.1. I >> am new in Matpower please corect me if I am doing wrong. >> >> Thanks, >> >> On Wed, Jan 11, 2012 at 12:00 AM, Arash Alimardani < >> [email protected]> wrote: >> >>> What do you mean other cases work? Are you using version 4.1? by "runse" >>> you mean "run_se"? >>> Do you get answer by runse('case14') without definging the measurement >>> parameters? >>> >>> >>> On Tue, Jan 10, 2012 at 4:00 PM, morteza keshavarz < >>> [email protected]> wrote: >>> >>>> Hello, >>>> >>>> I can't do state estimation for case118 system and It gives me error of: >>>> >>>> No remaining bad data, after discarding data 1 time(s). >>>> Largest value of B = NaN >>>> ??? NaN's cannot be converted to logicals. >>>> Error in ==> printpf at 168 >>>> nzld = find(bus(:, PD) | bus(:, QD)); >>>> Error in ==> runse at 187 >>>> printpf(baseMVA, bus, gen, branch, [], success, et, 1, mpopt); >>>> >>>> Other cases are working well after I just write : >>>> runse('case300') for example. I would be appreciate if some one tell me >>>> how I can fix for case118. >>>> >>>> Thanks, >>>> >>>> Morteza >>>> >>> >>> >> >
