If you are handy with a soldering iron there's an easy fix.
Buy a 6v @ 800ma adaptor and a 5 volt regulator...
This little three pin device will hold the 6v at a regulated 5v independent
of load...
This is what I had to do to run my Sharp 702 as the Japanese p/s is n/g in
Australia.
e-mail me if you want the circuit
GB
----- Original Message -----
From: Todd A. <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Thursday, 6 April 2000 1:57
Subject: MD: Sharp Frustration!
>
> Dear Mders,
>
> I've recently had a bad experience
> with my Sharp 702 MD.
>
> The AC Adaptor burnt out on me.
>
> I said, no problem go to the local
> electronics store, spend 12 dollars and
> get another.
>
> Since then I have searched all over NYC
> and all over the US via the internet and
> no one carries a 5v/800ma AC adaptor.
> They have every voltage EXCEPT
> the one I need.
-----------------------------------------------------------------
To stop getting this list send a message containing just the word
"unsubscribe" to [EMAIL PROTECTED]
