Hi, I have created meego kernel image and tried to flash it into n900 device using sdcard following the guidelines given in the following links
http://wiki.meego.com/ARM/N900/Install/MMC http://wiki.maemo.org/Flasher#Flasher-3.5_usage_examples But after i run the flasher command, meego is not booting. The device remains idle if switch off the device and start it normally boots using maemo After creation of raw image( also the kernel image ) i executed the "dd" command and copied the raw image into the sdcard, then did the following steps 1. Switch off the Maemo device 2. Press and hold down the 'u' key 3. Connect a USB cable between the Maemo device and host PC while holding down the 'u' key 4. When the USB cable is connected, it powers the Maemo device and sets it to flashing mode 5. When the USB icon appears in the upper right-hand corner, the Maemo device is in flashing mode 6. Release the 'u' key After that executed flasher cmd:# ./flasher-3.5 -l -b -k meego-handset-armv7l-n900-nokia-closed-1.0.80.8.20100630-1.0.80.20100720.0929-vmlinuz-2.6.35~rc5-126.4-n900 Can some body say what am I missing? Please give the correct procedure to flash the kernel image. Thanks in advance -- Regards, Sharavana
_______________________________________________ MeeGo-dev mailing list [email protected] http://lists.meego.com/listinfo/meego-dev
