Hi Sharavana, Seems your case is similar to mine. look the following: http://forum.meego.com/showthread.php?p=5828
as mention in the reply of the thread i tried modifying the kickstart file to point to Day One code drop. and it worked. seems something is wrong in the daily build for N900 UX. Thx, Mifraz On Tue, Jul 20, 2010 at 2:11 PM, Sharavana Ram Kumar Sundaresan <[email protected]> wrote: > Hi, > > I have created meego kernel image and tried to flash it into n900 device > using sdcard following the guidelines given in the following links > > http://wiki.meego.com/ARM/N900/Install/MMC > > http://wiki.maemo.org/Flasher#Flasher-3.5_usage_examples > > But after i run the flasher command, meego is not booting. > The device remains idle if switch off the device and start it normally boots > using maemo > > After creation of raw image( also the kernel image ) i executed the "dd" > command and copied the raw image into the sdcard, > then did the following steps > > Switch off the Maemo device > Press and hold down the 'u' key > Connect a USB cable between the Maemo device and host PC while holding down > the 'u' key > When the USB cable is connected, it powers the Maemo device and sets it to > flashing mode > When the USB icon appears in the upper right-hand corner, the Maemo device > is in flashing mode > Release the 'u' key > > After that executed flasher > > > cmd:# ./flasher-3.5 -l -b -k > meego-handset-armv7l-n900-nokia-closed-1.0.80.8.20100630-1.0.80.20100720.0929-vmlinuz-2.6.35~rc5-126.4-n900 > > Can some body say what am I missing? Please give the correct procedure to > flash the kernel image. > > Thanks in advance > > -- > Regards, > Sharavana > > > _______________________________________________ > MeeGo-dev mailing list > [email protected] > http://lists.meego.com/listinfo/meego-dev > > _______________________________________________ MeeGo-dev mailing list [email protected] http://lists.meego.com/listinfo/meego-dev
