Hi, If you get that error it's about the ability to mount the sdcard. I heard that in another thread it stated to unplug the device after writing with dd the raw image to it and then start it again with flasher.
I also encountered it another time, then I just rebooted back to Maemo, switched it off again and then to update mode. hth Tobias 2010/8/6 Sylvia Liu <[email protected]> > Hi, > > I found this a ks file for armv5tel from > http://forum.meego.com/showpost.php?p=6580&postcount=90 this morning. > Following the instructions, I created a raw image for armv5tel arch. > And I tried to start the image by -sd method. But the start sequence > stopped here: > > [ 1.976623] Power Management for TI OMAP3. > [ 2.123504] VFP support v0.3: implementor 41 architecture 3 part 30 > variant c rev 2 > [ 2.165435] omapfb omapfb: no driver for display > [ 2.166198] omapfb omapfb: failed to setup omapfb > [ 2.170654] regulator_init_complete: incomplete constraints, leaving > VCSI on > [ 2.201599] Waiting for root device /dev/mmcblk0p1... > > I also tried other weekly released images. Same things happened. > I think the problem is come from "omapfb omapfb: no driver for > display". But I don't know why there is no driver. > Does anyone work on this error now? > > BR, > Sylvia > _______________________________________________ > MeeGo-dev mailing list > [email protected] > http://lists.meego.com/listinfo/meego-dev >
_______________________________________________ MeeGo-dev mailing list [email protected] http://lists.meego.com/listinfo/meego-dev
