----- Original Message -----
From: Michael Cassidy <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Tuesday, April 18, 2000 4:12 PM
Subject: Clutch
> Any tips on getting the clutch plate/spigot allignment right? The
> price for a proper tool is a little high for me right now and i havn't
> found one i can borrow, i did an adjustment by eye and the g/box won't
> fully go in so i don't think it alligned right.
If you can get your hands on an old clobbered datto gearbox, cut off the
input shaft and use it as a alignment tool.
If you have enough experience, do it by touch. I used to do my RX4 by
feeling
the distance from the edge of the clutch plate to the edge of the pressure
plate
with my fingers, and make sure that it feels like the same distance at each
bolt hole. It worked for me many times. You have to take your time and not
rush
it though.
-Wayne
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.datascribe.com.au/ozdatonline/index.htm
http://www.datascribe.com.au/ozdatonline/listindex.html
---------------------------------------------------------------------
