The Aussie loom doesn't have hazard connections as such although it's easy to
install them. I've seen only one imported wagon with factory hazards, very
similar to the 180B but the 510 switch was about 10 mm shorter and had a
different picture on it.
terry
Albs wrote:
> I had a feeling that the 1600 has all the contectios for the hazard flasher
> relay are already there all you need to do is fit a relay into the
> contection socket found behind the gauge set (same pin config as the
> indicator one) and wire in a switch. But don't quote me on it.
> I noticed this when i was rewiring my 1600 but i did'nt test my theory.
> albs
>
> >Me three!
> >
> >-----Original Message-----
> >From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
> >Sent: Friday, May 26, 2000 11:05
> >To: [EMAIL PROTECTED]
> >Subject: RE: Hazard Lights
> >
> >
> >Terry, would you please be able to send me the diagram too? I was
> >going to figure it out myself, but its always easier if someones
> >done it before!!
> >Thanks
> >Andrew
> >[EMAIL PROTECTED]
> >
> >Subject: RE: Hazard Lights
> >
> >> Thanks Terry. That would be great. I'll see if I can get the bits. Does
> >> anyone on the list have a switch and hazard relay unit off a 180B? I am in
> >> the Sydney area if you do.
> >>
> >> Terry, if you can send me the diagram whenever you get a chance I'd
> >> appreciate it. Thanks.
> >>
> >> Regards,
> >> Carmi.
> >>
> >> > -----Original Message-----
> >> > From: [EMAIL PROTECTED]
> >> > [mailto:[EMAIL PROTECTED]]On Behalf Of Terry &
> >> > Heather
> >> > Sent: Friday, May 26, 2000 7:53 AM
> >> > To: [EMAIL PROTECTED]
> >> > Subject: Re: Hazard Lights
> >> >
> >> >
> >> > Carmi,
> >> > It's dead easy, you need the switch and hazard relay unit off a
> >> > 180B. I have a
> >> > wiring diagram to follow for the connections required into the
> >> > standard 1600
> >> > loom which by the time you get your bits i'll be able to send to
> >> > you - i wont
> >> > be near a computer for a few days.
> >> >
> >> > regards
> >> >
> >> > terry
> >> >
> >> > Carmi Cronje wrote:
> >> >
> >> > > G'day Dato Members,
> >> > >
> >> > > Has anyone on the list installed hazard lights in their Dato
> >> > 1600? If so,
> >> > > could you please let me know how you did it.
> >> > >
> >> > > I had a bit of an incident on a major highway the other night
> >> > where myself
> >> > > and a couple of mates had to push my car a "few" meters until
> >> > we reached a
> >> > > servo. A few of the cars coming up from behind didn't notice us
> >> > until the
> >> > > last minute...a bit of a hairy situation :-0
> >> > >
> >> > > Regards,
> >> > > Carmi.
> >> > >
> >> >
> >>
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.datascribe.com.au/ozdatonline/index.htm
http://www.datascribe.com.au/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
