you run it in series with the coil. IE. power goes to the tacho and then
out to the coil. So if you unplug you tacho you car wont start.
----- Original Message -----
From: luke heymans <[EMAIL PROTECTED]>
To: ozdat <[EMAIL PROTECTED]>
Sent: Monday, July 31, 2000 12:32 PM
Subject: tacho questions
> list,
> I recently purchased a SSS dashboard cluster for my 180B. I am having
> problems with the wiring as my model was not a SSS. I have the power
> wiring sorted but there is a wire that runs right through the tach which
> is black with a blue stripe. It has 2 spade connections on it, different
> one on each end. Now the wire runs through a metal ring and is near a
> coil.
> My thoughts are that a voltage/current is needed to pass through the
> wire and that current will induce a voltage in the coil near it and
> subsequently work the tacho.
> Is this correct?
> Also where do i hook the wires to??? The negative of the coil and then
> to earth??
> All SSS tacho's should be the same so could someone have a look and get
> back to me.
> cheers
> Luke (180B) Heymans
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
