I bet you were stuffed around. Who annoyed you more Customs or your
contact in NZ? The Z18 will run fine from just the computer loom. Do you
have a pin-out for the computer as I have one laying around. The TPS are
not variable they are just idle/WOT so anything from nissan will bolt on, I
have seen a few around.
At 17:26 25/09/2000 +1000, you wrote:
>Hi all
>
>Well the Z18et's turned up from NZ.... Ordered 4,
>got 2 complete + some bits, with the other 2 on back order :(
>Talk about a stuff around...But that's another sad and long
>story which I'll leave for another time.....
>
>Got a couple of question for those of you that have Z18's
>
>On the 2 complete units we did get there are 3 boxes, the fuel
>computer the knock control module and a third box with TCU
>written on it? It would have been located under the Dash on
>the Main loom (not on the Computer loom) ...
>anybody know what this is??
>Is this the EI module, or is that in the Dissy?
>
>Also a couple of the TPS's (throttle position sensors) were
>damaged... what other TPS's from other motors have people used??
>
>Also on the Motor Loom (not the computer loom) was a little black
>box with 'Boost control module' written on it .... I gather this was
>just
>used for the electronic boost gauge and didn't actually have any other
>function as it doesn't seem to connect to the computer loom??
>(except for maybe overboost cut) Should be ok if left disconnected??
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
