hi,
could any one please tell me exactly how to go about putting the z2.4 crank
in a l20b?
some one put me onto a site ,it was pretty good , but not exactly what i
needed.
this is what i have already done:
l20b block bored 1mm
crank tunnel line bored
deck surfaced
after i had this ALL done i found i could get a z2.4 crank.
what do i have to do to make it fit into this block?
i am also running a fj20 turbo .63 housing and fuel injection.
thanks, mark
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
