The boot seal is a good one to avoid as it traps water and promotes rust
under it.  A good replacement is a seal which glues under the boot lid about
20mm further out than the original seal.  If you get the right rubber
profile it will exclude water and exhaust fumes when the boot is closed.
When the boot is open, water flows down the channel around the boot opening
and out at the lower drain locations.  You can keep the drain channel clean
and rust free.

----- Original Message -----
From: "ryanmel" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Sunday, 15 April 2001 11:29 AM
Subject: Re: baily channel


> theres a few places around that sell all the seals you need for a datto.
> i replaced all of them in mine, the bailey channels, the inner and outer
> door belt moulds (at the bottom of the window) you can buy the boot seal,
> door seals, the lot... rare spares or rex spares in WA sell them, but you
> see ads for a complete kit in some of the old FF&R mags.
>
> ryan
>
> ----- Original Message -----
> From: Richard Clough <[EMAIL PROTECTED]>
> To: <[EMAIL PROTECTED]>
> Sent: Friday, April 13, 2001 4:45 PM
> Subject: Re: baily channel
>
>
> > Continue the bailey channel down to the bottom.
> > ----- Original Message -----
> > From: "damien cm" <[EMAIL PROTECTED]>
> > To: <[EMAIL PROTECTED]>
> > Sent: Thursday, 12 April 2001 12:27 PM
> > Subject: Re: baily channel
> >
> >
> > >
> > >
> > > Thomas,
> > >
> > > I bought mine at place called 'Clark Rubber'in Fyshwick, ACT. I think
> > there
> > > are branches through out Australia. It cost about $7 a meter plus
about
> > $10
> > > for the contact adhesive(essential). It made a big difference in
> stopping
> > > that whistling sound at high speed and will ensure a warm cabin this
> > winter.
> > >
> > > I could'nt find anything for the bottom of the window though, any
> > > suggestions anyone???
> > >
> > > Good luck,
> > >
> > > Damien
> > >
> _________________________________________________________________________
> > > Get Your Private, Free E-mail from MSN Hotmail at
> http://www.hotmail.com.
> > >
> >
>

--membersozdat-------------------------------------------------------
OZDAT Mailing List   Please Note:-
Send (un)subscribe requests to  [EMAIL PROTECTED]
Send  submissions to  [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------

Reply via email to