Eric
The L13 rods are 7mm longer than the stock rods. This length increase allows
a significantly lower compression height piston to be used. This also means
the piston would be much lighter normally.
Cheers
Feral Errol
mailto:[EMAIL PROTECTED]
http://www.datrats.com.au/
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Eric
Sent: Sunday, April 29, 2001 6:46 PM
To: [EMAIL PROTECTED]
Subject: Re: Cast iron L series heads
Errol
Are the rods in the L13 better to use because of being longer than 1600 and
180B ? I am looking at a new motor for mine and want to build up a fairly
strong one based on a 180B. I can get a hold of the L13 rods and was
wondering whether this is a good option.
Thanks for any assistance.
Eric
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
