Terry,
Thanks for the advice. The cable has to be bent to go through the fire wall
and then across to the other side of the motor where the carbies are
attached. It is not so much of a bend, but it is enough to make it nearly
impossible to pull the choke cable when both carbies are hooked up. I will
try it just on the front carbie and see how I go, do you think this wouuld
be enough to get the engine going?
Thanks
>From: "Terry Rudd" <[EMAIL PROTECTED]>
>Reply-To: [EMAIL PROTECTED]
>To: <[EMAIL PROTECTED]>
>Subject: RE: Choke cable for twin 40mm delortos wanted
>Date: Tue, 26 Jun 2001 20:24:54 +1000
>
>Lachlan,
>With twins you shouldn't have to bend the cable and also you usually only
>connect the cable to the front carbie. Most of the time you should be able
>to start with side drafts without a choke, hold the throttle at 1500 rpm
>for
>20 seconds and drive away.
>
>regards
>Terry
>
>-----Original Message-----
>From: [EMAIL PROTECTED]
>[mailto:[EMAIL PROTECTED]]On Behalf Of Lachlan Hughes
>Sent: Tuesday, 26 June 2001 2:19
>To: [EMAIL PROTECTED]
>Subject: Choke cable for twin 40mm delortos wanted
>
>
>Does anyone have a choke cable for twin 40mm delortos. I purchased an
>aftermarket cable from Repco but as soon as you bend the cable it is nearly
>impossible to pull out, therefore i thought it may be best to try and
>locate
>and original set up.
>Thanks in advance
>Lachlan
>_________________________________________________________________________
>Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
>
>
_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
