Terry,
The car is often hard to start in cold weather that is why I would like to 
hook up a choke.  The cable I brought is a metal aftermarket one, it is the 
one with like a tight coil outer with a thin wire, coathanger width in the 
middle.  The outside is like a compresed coil, but even with the slight s 
bend in the cable when I run it the same way as the factory cable, but it is 
still impossible to pull out.  I will have a look around for some other 
cables to see if any better than my existing one otherwise I may have to try 
the wreckers.
Thanks


>From: "Terry Rudd" <[EMAIL PROTECTED]>
>Reply-To: [EMAIL PROTECTED]
>To: <[EMAIL PROTECTED]>
>Subject: RE: Choke cable for twin 40mm delortos wanted
>Date: Wed, 27 Jun 2001 19:08:11 +1000
>
>Lachlan,
>
>Very rarely do you need to use the choke to start with twins or even a
>single sidedraft unless you park it outside in sub zero temps like in
>Canberra. A couple of pumps is enough to get things into life. I actually
>have a choke cable hooked up but very rarely use it. I run my cable exactly
>along the same route as the stock cable but as it's all metal I used a 
>piece
>of fuel line as an insulator across the corner of the rocker cover. There
>are gentle curves in it this way, bit like an S but nothing that I would
>call a bend that would kink the cable. Good quality aftermarket cables that
>are all metal seem to be the best.
>
>regards
>Terry
>
>-----Original Message-----
>From: [EMAIL PROTECTED]
>[mailto:[EMAIL PROTECTED]]On Behalf Of Lachlan Hughes
>Sent: Wednesday, 27 June 2001 2:29
>To: [EMAIL PROTECTED]
>Subject: RE: Choke cable for twin 40mm delortos wanted
>
>
>Terry,
>Thanks for the advice.  The cable has to be bent to go through the fire 
>wall
>and then across to the other side of the motor where the carbies are
>attached.  It is not so much of a bend, but it is enough to make it nearly
>impossible to pull the choke cable when both carbies are hooked up.  I will
>try it just on the front carbie and see how I go, do you think this wouuld
>be enough to get the engine going?
>Thanks
>
>
>

_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.

--membersozdat-------------------------------------------------------
OZDAT Mailing List   Please Note:-
Send (un)subscribe requests to  [EMAIL PROTECTED]
Send  submissions to  [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------

Reply via email to