Re: Microtech stuff

[andrew smith]

I'm not exactly sure on how to test them.Have you tried the new one yet. Andrew Smith FJ510 wrote: i've heard that the o2 sensor fluctuates up and down in a wave (which is why an oscilliscope would be good)mine was doing that but it was between 0.365V and 0.600V yet it was only flickering between 17.5 and 18.0 A/F i have bought another O2 sensor...for general knowledge the genuine nissan item for a DR30 FJ20DET is the sameas a CA20 Pintara. after a few parts supersessions.   ----- Original Message ----- From: Rowe, Adam To: '[EMAIL PROTECTED]' Sent: Wednesday, February 20, 2002 11:26 AM Subject: RE: Microtech stuff  You can measure the voltage of the O2 Sensor.  It should read 0-1V.  0.5-0.7 is normally 14:1.  For normal driving it should cycle (not flickering just up and down) from around 0.1-0.9V.  Make sure you use a Multimeter which has an input impedance of greater than 1M ohm. -----Original Message----- From:   FJ510 [SMTP:[EMAIL PROTECTED]] Sent:   19/02/2002 19:07 To:     [EMAIL PROTECTED] Subject:        Re: Microtech stuff what do i measure?  i can't measure lambda, is there a parallel measurement in voltage or ohms or something? and it used to drop to 12.2 when i was on the noise, but yesterday, it was all 17 - 18 i don't want to shatter another FJ like i did 3 weeks ago   ----- Original Message ----- From: andrew smith <mailto:[EMAIL PROTECTED]> To: [EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]> Sent: Tuesday, February 19, 2002 7:19 AM Subject: Re: Microtech stuff Ryan, The O2 sensors can be checked as it sounds like it might be faulty.17's are fine for cruising at light throttle but that should change as soon as you put your foot into it and should be down to 11.5 once boost has arrived. Andrew Smith FJ510 wrote: does anyone have a fuel map for the FJ20DET for a Microtech.until i can get it dyno-tuned i want to semi fix it.  I think it's runningreally REALLY lean.  the A/F reading on my Microtech is reading 17.5when I'm driving, which to me says 17.5 parts air to 1 part fuel which islean but when i adjust the mixture trim on the handset for more fuel itflicks between 17.5 and 18.0 like it's going backwards so i can't reallytrust it. --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email <http://www.ozdat.com/ozdatonline/index.htm> <http://www.ozdat.com/ozdatonline/listindex.html> <http://www.mail-archive.com/membersozdat@datascribe.com.au/> ---------------------------------------------------------------------   --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ ---------------------------------------------------------------------   --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ --------------------------------------------------------------------- --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ --------------------------------------------------------------------- --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ --------------------------------------------------------------------- --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ ---------------------------------------------------------------------