adjustable radius rods...

[Ben C]

had my radius rods out....and i was going to put the on the lathe and thread them further down so they had more adjustment.....but then i thort, if i start pulling the radius rod in, the lower control arm is going to want to go on an angle, when they were designed to stick straight out from the xmember....what the go there?? do you slot the holes on the xmember so it can sit at an angle other than 0d??? or do the bushes in the xmember have enuff give to let you pull a bit on the radius rod??? --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ ---------------------------------------------------------------------