|
The inner bushes can take a bit of a twist to allow
you to pull the radius arms forward, but dont go overboard. The bolt is welded
through the crossmember so its not adjustable (easily).
----- Original Message -----
Sent: Thursday, 31 October 2002 9:37
AM
Subject: adjustable radius rods...
had my radius rods out....and i was going to put
the on the lathe and thread them further down so they had more
adjustment.....but then i thort, if i start pulling the radius rod in, the
lower control arm is going to want to go on an angle, when they were designed
to stick straight out from the xmember....what the go there?? do you slot the
holes on the xmember so it can sit at an angle other than 0d??? or do the
bushes in the xmember have enuff give to let you pull a bit on the radius
rod???
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to
[EMAIL PROTECTED]
Send submissions to
[EMAIL PROTECTED]
No unauthorised redistribution of this
email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
--------------------------------------------------------------------- |
