|
what bolt is welded??? this is a bluebird, not a
16
im just going to make adjustable strut tops anyway,
ill setup my castor/camber from there
----- Original Message -----
Sent: Thursday, October 31, 2002 10:26
PM
Subject: Re: adjustable radius
rods...
The inner bushes can take a bit of a twist to
allow you to pull the radius arms forward, but dont go overboard. The bolt is
welded through the crossmember so its not adjustable (easily).
----- Original Message -----
Sent: Thursday, 31 October 2002 9:37
AM
Subject: adjustable radius
rods...
had my radius rods out....and i was going to
put the on the lathe and thread them further down so they had more
adjustment.....but then i thort, if i start pulling the radius rod in, the
lower control arm is going to want to go on an angle, when they were
designed to stick straight out from the xmember....what the go there?? do
you slot the holes on the xmember so it can sit at an angle other than 0d???
or do the bushes in the xmember have enuff give to let you pull a bit on the
radius
rod???
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to
[EMAIL PROTECTED]
Send submissions to
[EMAIL PROTECTED]
No unauthorised redistribution of this
email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to
[EMAIL PROTECTED]
Send submissions to
[EMAIL PROTECTED]
No unauthorised redistribution of this
email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
--------------------------------------------------------------------- |
