hi, if ya interested i have a "PUROLATOR" pro fuel brand fuel regulator which should be suitable.... i can send u a pic if ya want ... email me [EMAIL PROTECTED]
mark k ----- Original Message ----- From: "Rob P" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Friday, July 18, 2003 2:57 PM Subject: Re: electric fuel pumps and downdraft Weber > Ahhh, that I didn't know. So I guess the best regulator would be a Malpassi > rising rate regulator which I have heard alot about? Or is there a cheaper > type 'cos I hear the Malpassi is a bit expensive. Anyone got one for sale? > Sorry about my lack of knowledge about Webbers, this is my first twin 45 > sidedraft setup and the motor has still not been installed or tested and I > just want to make sure I get it right. > I would hate to "hydraulic" the motor like your mate did, thanks for the > tip. I remember my high school science class lesson "liquids are > un-compressible" looks like your mate found out the hard way, poor bugger. > Anyway, hopefully I won't be collecting tree stumps or rocks under the car > as my aim is to stay ON the roads. You say in-cabin fuel lines ARE legal, > but what state are you in? Also, the bundy tube I purchased a few years back > had a copper coating and was very, very soft. I would be worried about it > getting squashed or dented by wayward stones under the car. Is there various > types of bundy tube or are they all that soft? Working under the Datsun last > night I noticed that the 31-year-old fuel line is still shiny underneath the > road grime. Is the stock fuel line aluminium or stainless steel? It looked > alot like alloy to me but might just be a galvanised coating, any ideas? > > Cheers, > Rob P > > > ----- Original Message ----- > From: "Mick Ralph" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Friday, July 18, 2003 6:15 AM > Subject: Re: electric fuel pumps and downdraft Weber > > > > Rob > > Wow They would hate my car then. HAHAHA > > Actually, so long as there are no joins in the fuel line INSIDE the cabin > it > > is quite legal and quite safe. In fact for rally car it should be safer ie > > less chance of snagging the fuel lines on tree stumps and the like. > > I guess the real issue I wanted to raise was having a fuel regulator to > keep > > the pressure OFF the needle and seats in the webers. A while ago a mate of > > mine with a similar set up to mine but no fuel reg and leaky needle and > > seats, parked on the side of the road with the left side of the car up on > > the footpath. The weakened and leaky needle and seats in the webers > allowed > > fuel to pour into the cylinders while the car was parked. Sure enough when > > he came back to start it the cylinders were full of fuel and he bent 2 > rods > > and ruined a really good engine. There's a lesson there somewhere based on > > my mates expenses... hehe > > Cheers > > Mick > > > > ----- Original Message ----- > > From: "Rob P" <[EMAIL PROTECTED]> > > To: <[EMAIL PROTECTED]> > > Sent: Friday, July 18, 2003 12:00 AM > > Subject: Re: electric fuel pumps and downdraft Weber > > > > > > > Yeah thanks Mick, that setup is exactly what I've got in an ex-racing > 510 > > > shell > > > I used to drive around a few years ago. Unfortunately that car was given > a > > > defect notice, as here in WA running fuel lines inside a street car is > not > > > allowed (or so the cops told me). That was just one of the reasons I had > > to > > > take that car off the road, the guy at the pits didn't take too kindly > to > > > the alloy roll cage (CAMS approved and logbooked) either, or the lack of > > > carpets, rear seat, battery in boot, missing wheel well or the hydraulic > > > handbrake etc. I think I was done over a bit harshly because there was a > > bit > > > of a campaign against old cars on the road at the time. > > > The new shell I'm working on is a '72 and I'll be trying to keep it road > > > licensed so I can use it in historic tarmac rallies and autokhanas. > > > I will run the bigger lines as you and Errol have suggested but I'll run > > > them outside the car to save any hassle later. I guess I'll have to > > hire/get > > > some kind of tube bending die thingy for the job. > > > Thanks for the advice guys. > > > > > > Rob P > > > > > > ----- Original Message ----- > > > From: "Mick Ralph" <[EMAIL PROTECTED]> > > > To: <[EMAIL PROTECTED]> > > > Sent: Thursday, July 17, 2003 7:04 PM > > > Subject: Re: electric fuel pumps and downdraft Weber > > > > > > > > > > Rob > > > > I agree with everything said so far. > > > > My worked L20B in a 510, with twin 45's has 2 shitty old low pressure > > fuel > > > > pumps in the boot and I run 3/8" Bundy thru the cabin up the > passengers > > > side > > > > of the transmission tunnel, then up the firewall and across to the far > > > left > > > > so that it exits into the engine bay below the shelf just below the > > wiper > > > > motor. > > > > The steel pipe finishes here and i've got a small length of rubber > hose > > > then > > > > a right angle fuel filter tucked under the strut gusset then a short > > > rubber > > > > hose runs back to a fuel regulator (set at 2.5) which just rests on > > that > > > > shelf under the wiper motor. From the regulator to the rearmost Weber > is > > > > just another short piece of rubber fuel hose. Man I wish I had a > digital > > > > camera!!!!! If u want more info just email me offlist. > > > > It looks neater than it sounds. > > > > You do need min 3/8" Bundy. > > > > You do need a fuel regulator for webers. Thats why Errol is so right > > about > > > > using the bluey pump. But I didn't know a bluey pump could handle that > > > much > > > > HP. hmmm Fuel regs are about $100. I've thrown out bluey pumps! Doh!! > > > > Hope this helps > > > > Cheers > > > > Mick > > > > ----- Original Message ----- > > > > From: "E Smith" <[EMAIL PROTECTED]> > > > > To: <[EMAIL PROTECTED]> > > > > Sent: Thursday, July 17, 2003 6:36 PM > > > > Subject: RE: electric fuel pumps and downdraft Weber > > > > > > > > > > > > > Run at least 3/8" lines from the tank all the way forward. 10 mm or > > 1/2" > > > > > preferred. > > > > > > > > > > > > > > > Cheers, > > > > > Feral Errol > > > > > Get Serious tm<http://www.datrats.com.au/> > > > > > > > > > > > > > > > > > > > > -----Original Message----- > > > > > From: [EMAIL PROTECTED] > > > > > [mailto:[EMAIL PROTECTED] Behalf Of Rob P > > > > > Sent: Thursday, July 17, 2003 11:07 AM > > > > > To: [EMAIL PROTECTED] > > > > > Subject: Re: electric fuel pumps and downdraft Weber > > > > > > > > > > > > > > > Thanks Errol, > > > > > So what diameter lines do I need? You mean from fuel tank to motor > AND > > > > > return line? > > > > > Currently the 510 shell I'm working on has no return line. Bundy > > tubing > > > > OK? > > > > > > > > > > Rob P > > > > > > > > > > ----- Original Message ----- > > > > > From: "E Smith" <[EMAIL PROTECTED]> > > > > > To: <[EMAIL PROTECTED]> > > > > > Sent: Thursday, July 17, 2003 4:50 AM > > > > > Subject: RE: electric fuel pumps and downdraft Weber > > > > > > > > > > > > > > > > Rob. > > > > > > The bluey pump will do up to 200 hp output with big lines. > > > > > > > > > > > > Vl turbo pumps are high pressure (45 psi) you need 2.5 Psi. > > > > > > > > > > > > Cheers, > > > > > > Feral Errol > > > > > > Get Serious tm<http://www.datrats.com.au/> > > > > > > > > > > > > > > > > > > > > > > > > -----Original Message----- > > > > > > From: [EMAIL PROTECTED] > > > > > > [mailto:[EMAIL PROTECTED] Behalf Of Rob P > > > > > > Sent: Wednesday, July 16, 2003 10:02 PM > > > > > > To: [EMAIL PROTECTED] > > > > > > Subject: Re: electric fuel pumps and downdraft weber > > > > > > > > > > > > > > > > > > What about a wild L20B with twin 45s? Is the BBird pump enough or > do > > I > > > > > need > > > > > > a VL turbo fuel pump, with or without a fuel regulator? > > > > > > > > > > > > Cheers, > > > > > > Rob P > > > > > > ----- Original Message ----- > > > > > > From: "Kristian Walsham" <[EMAIL PROTECTED]> > > > > > > To: <[EMAIL PROTECTED]> > > > > > > Sent: Tuesday, July 15, 2003 8:53 AM > > > > > > Subject: Re: electric fuel pumps and downdraft weber > > > > > > > > > > > > > > > > > > > Andrew, > > > > > > > If you run a S2 BB electric pump you don`t need a > > > > > regulator. > > > > > > > The pressure isn`t high, it just flows more. > > > > > > > Aftermarket pumps maybe another story, so you will have find out > > > what > > > > > > > pressure they run at. > > > > > > > I have this pump on my car now still with the 32/36 and it > doesn`t > > > run > > > > > out > > > > > > > of fuel. > > > > > > > > > > > > > > Kris. > > > > > > > ----- Original Message ----- > > > > > > > From: "Andrew Greenbury" <[EMAIL PROTECTED]> > > > > > > > To: <[EMAIL PROTECTED]> > > > > > > > Sent: Tuesday, July 15, 2003 10:37 AM > > > > > > > Subject: electric fuel pumps and downdraft weber > > > > > > > > > > > > > > > > > > > > > > Hi List, > > > > > > > > > > > > > > > > I understand electric fuel pumps such as the bluebird one > should > > > be > > > > > > > > used with a regulator if running a downdraft weber because > they > > > > supply > > > > > > > > too much pressure. My 32/36 downdraft runs a fuel return so > > would > > > > > > > > this make the use of a regulator redundant? > > > > > > > > > > > > > > > > Thanks, > > > > > > > > Andrew > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[EMAIL PROTECTED]/ ---------------------------------------------------------------------
