sorry to repeat, but what is the sequence for wiring these up, the 2 whites u can join togetherfor the negative on coil, the green goes to 12V+ and the black is a normal negative??? is there a coloured wire behind the dash that they hook up to???
The tacho i have has an orange needle like the speedo,with a white ring the same as the speedo, and have never seen another one like it..... any ideas.....



From: "Zac Campbell" <[EMAIL PROTECTED]>
Reply-To: [EMAIL PROTECTED]
To: <[EMAIL PROTECTED]>
Subject: Re: Datsun factory tacho
Date: Mon, 12 Jul 2004 10:02:15 +0930

The two white wires go in series with the negative side of the ignition
coil.


----- Original Message ----- From: "Mark" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Sunday, July 11, 2004 10:33 PM Subject: Datsun factory tacho


> I have a Datsun tacho I'd like to check, which I guess will need +12v, > gnd and negative signal from coil at a minimum. > The wires on the back are: white (male), white (f), black and green. I > thinking black ->gnd, green->12v. > > Mark. > > > >




_________________________________________________________________
SEEK: Now with over 50,000 dream jobs! Click here: http://ninemsn.seek.com.au?hotmail



--membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[EMAIL PROTECTED]/ ---------------------------------------------------------------------



Reply via email to