On Tue, Jul 31, 2012 at 12:31:10AM +0000, [email protected] wrote: > Incidentally, I don't get all of the kernel boot messages when my gumstix > boots. It says > > Starting kernel ... > > Uncompressing Linux... done, booting the kernel. > > Yocto (Built by Poky 7.0) 1.2+snapshot-20120730 overo ttyO2 > > overo login: > > > And then I'm at the login prompt. I'm assuming there is some boot setting > which controls this? All of the messages are showing up in > /var/log/messages, however.
What's your "bootargs" variable in u-boot? Does it contain "quiet"? Does it have the proper console settings? -- Denys > On Jul 30, 2012, at 12:42 PM, ext Denys Dmytriyenko wrote: > > > On Mon, Jul 30, 2012 at 07:10:23PM +0000, [email protected] wrote: > >> Hmm. I don't see to have depmod installed. Perhaps that is part of my > >> problem. What package would I need to add to the minimal-core-image to get > >> that? > > > > Josh, > > > > core-image-minimal uses busybox for tools like insmod and modprobe. The > > default configuration for busybox does not have depmod enabled. As of > > module-init-tools, they are being built, but not installed on the > > filesystem. > > So, you can either modify busybox config to enable depmod, or add > > module-init-tools-depmod package to your filesystem. The new way is to use > > kmod, which is available in oe-core master, or meta-oe in denzil. But > > oe-core > > master setup is broken for me at the moment, so I can't verify that kmod is > > included. At least it's not listed in the image/task... > > > > Denys > > > > > >> On Jul 30, 2012, at 1:07 AM, ext Enrico wrote: > >> > >>> On Sat, Jul 28, 2012 at 9:30 PM, <[email protected]> wrote: > >>>> This does work. When I boot the wpa stuff is included but I still don't > >>>> have a network driver loaded. If I include the built > >>>> modules-3.2.19-r0-overo.tgz in my rootfs I can cd into the directory > >>>> with all of the modules. However insmod libertas.ko fails with > >>>> > >>>> insmod: can't insert 'libertas_tf_usb.ko': unknown symbol in > >>>> module, or unknown parameter > >>>> > >>>> and modprobe fails with > >>>> > >>>> modprobe: module libertas not found in modules.dep > >>>> > >>>> > >>>> So, what should I do to make sure the libertas module is compiled > >>>> correctly, included in my kernel, and then actually used at runtime? > >>> > >>> try with "depmod -a" (this must be done only once after you untar the > >>> modules) before modprobe libertas. > >>> > >>> I am not sure but i think it was "modprobe libertas_sdio", try that > >>> too. And of course you will need the libertas firmware > >>> (sd8686....bin). > >>> > >>> Enrico > >> > >> _______________________________________________ > >> meta-ti mailing list > >> [email protected] > >> https://lists.yoctoproject.org/listinfo/meta-ti > > _______________________________________________ > meta-ti mailing list > [email protected] > https://lists.yoctoproject.org/listinfo/meta-ti > _______________________________________________ meta-ti mailing list [email protected] https://lists.yoctoproject.org/listinfo/meta-ti
