Hello Mark, > I have updated these (force push). pmu-firmware is now building the proper > 2020.2 version, again, I've not verified it's functional -- just that it's > building.
Re-cloned. (Thanks for the anti-fool test of not including meta-microblaze, your assumption was right.) The PMU builds and boots on my ZCU102 board in the SPL boot flow against mainstream U-Boot. Binary file is same size as from the Xilinx 2020.2 pre-built BSP, md5sum is different. PMUFW: v1.1 Loading new PMUFW cfg obj (2200 bytes) EL Level: EL3 Chip ID: zu9eg Multiboot: 0 Trying to boot from MMC2 spl: could not initialize mmc. error: -19 Trying to boot from MMC1 spl_load_image_fat_os: error reading image u-boot.bin, err - -2 NOTICE: ATF running on XCZU9EG/silicon v4/RTL5.1 at 0xfffea000 NOTICE: BL31: v2.2(release):xilinx_rebase_v2.2_2020.1-10-ge6eea88b1 NOTICE: BL31: Built : 06:05:12, Nov 19 2020 U-Boot 2021.01 (Jan 21 2021 - 12:39:47 +0000) Model: ZynqMP ZCU102 Rev1.0 Board: Xilinx ZynqMP DRAM: 4 GiB PMUFW: v1.1 EL Level: EL2 Chip ID: zu9eg WDT: Started with servicing (60s timeout) NAND: 0 MiB MMC: mmc@ff170000: 0 Loading Environment from FAT... *** Warning - bad CRC, using default environment In: serial Out: serial Err: serial Bootmode: LVL_SHFT_SD_MODE1 Reset reason: EXTERNAL Net: ZYNQ GEM: ff0e0000, mdio bus ff0e0000, phyaddr 12, interface rgmii-id Warning: ethernet@ff0e0000 (eth0) using random MAC address - de:ed:27:5b:e6:11 eth0: ethernet@ff0e0000 Hit any key to stop autoboot: 0
-=-=-=-=-=-=-=-=-=-=-=- Links: You receive all messages sent to this group. View/Reply Online (#4844): https://lists.yoctoproject.org/g/meta-xilinx/message/4844 Mute This Topic: https://lists.yoctoproject.org/mt/80113688/21656 Group Owner: [email protected] Unsubscribe: https://lists.yoctoproject.org/g/meta-xilinx/unsub [[email protected]] -=-=-=-=-=-=-=-=-=-=-=-
