Mark.. Is the "ground endmill" some sort of bull mill. I cant get correct toolpath whit bull mill when programming mesh.
Holst At 00:43 00.02.01 EST, you wrote: >i was pocketing a mold with islands recently.the islands were tricky shapes >and i had to finish them with a specially ground endmill.i programmed in the >pocket control box to leave .02 on the walls.it did leave .02 on the pocket >walls but actually came closer to the islands in some spots .one spot only >.005.this was too close in some spots and i had to face it off and start >over leaving more.is it common for this to happen? >mark >______________________________________________________ >Get Your Private, Free Email at http://www.hotmail.com > >====================================================================== >To find out more about this mailing list including how to unsubscribe, >send the message "info mfg-smartcam" to [EMAIL PROTECTED] >====================================================================== > PROTOTECH AS P.O. Box 6034 N-5892 Bergen, Norway. ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
