Dave, The config.pro option "IGES_OUT_TRIM_XYZ NO" tells Pro/E not to output construction geometry (wire frame), but if there're construction surfaces, then a separate quilt of surface needs to be created for export, else Pro/E will export the whole thing whether it is blank or unblank.
Hope this clears things up! Chinh > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED]]On Behalf Of Dave Hayden > Sent: Tuesday, May 02, 2000 9:03 AM > To: [EMAIL PROTECTED] > Subject: Re: [mfg-smartcam] Re: RS-232 port - IGES thread > > > First an apology, when I sent my original message regarding > the Pro/E IGES > files, I got lazy and just used "reply" rather than typing in > the email > address. Unfortunately, I neglected to change the subject > and we now have > a misleading thread. > > Thanks so for some good comments and suggestions. I have two other > questions. > > Since it appears that our settings may have been correct, is > it possible > that the way our Engineers are designing the model is causing > our problems > rather than the translation to IGES? Or, could it be they > are not blanking > off some entities prior to export? > > David > > > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== > ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
