Chinh I just tried your suggestion as we also have the same problems with SmartCAM iges files with no success.
A couple of questions: 1. Does it matter where in the config.pro that these lines need to be placed? I have it just after the area that starts my query bin, placement of the model tree, etc. 2. On the lines you told us to put in, I am assuming that you have a space between the words as & 128, 128 & YES, XYZ & NO, 143 & YES. If you have any other suggestions, don't hesitate to send them my way. Brock Shimon -----Original Message----- From: Chinh N Pham <[EMAIL PROTECTED]> To: 'Dave Hayden' <[EMAIL PROTECTED]>; [EMAIL PROTECTED] <[EMAIL PROTECTED]> Date: Tuesday, May 02, 2000 10:45 AM Subject: RE: [mfg-smartcam] Re: RS-232 port - IGES thread >Dave, > >The config.pro option "IGES_OUT_TRIM_XYZ NO" tells Pro/E not to output >construction geometry (wire frame), but if there're construction surfaces, >then a separate quilt of surface needs to be created for export, else Pro/E >will export the whole thing whether it is blank or unblank. > >Hope this clears things up! > >Chinh > >> -----Original Message----- >> From: [EMAIL PROTECTED] >> [mailto:[EMAIL PROTECTED]]On Behalf Of Dave Hayden >> Sent: Tuesday, May 02, 2000 9:03 AM >> To: [EMAIL PROTECTED] >> Subject: Re: [mfg-smartcam] Re: RS-232 port - IGES thread >> >> >> First an apology, when I sent my original message regarding >> the Pro/E IGES >> files, I got lazy and just used "reply" rather than typing in >> the email >> address. Unfortunately, I neglected to change the subject >> and we now have >> a misleading thread. >> >> Thanks so for some good comments and suggestions. I have two other >> questions. >> >> Since it appears that our settings may have been correct, is >> it possible >> that the way our Engineers are designing the model is causing >> our problems >> rather than the translation to IGES? Or, could it be they >> are not blanking >> off some entities prior to export? >> >> David >> >> >> ====================================================================== >> To find out more about this mailing list including how to unsubscribe, >> send the message "info mfg-smartcam" to [EMAIL PROTECTED] >> ====================================================================== >> > >====================================================================== >To find out more about this mailing list including how to unsubscribe, >send the message "info mfg-smartcam" to [EMAIL PROTECTED] >====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
