The web site is http://members.aol.com/macgencnc/fullimg.htm.
> I downloaded a program called MacGen (free). Works better than Revgen (tape > to shape) that came with one of the Smartcam releases. I don't have the > address though. There was a post to the forum not too long ago. > > > -----Original Message----- > > From: Williams, Colin [SMTP:[EMAIL PROTECTED]] > > Sent: Thursday, August 03, 2000 4:03 PM > > To: Smartcam Forum > > Subject: [mfg-smartcam] code > > > > What is the name of the software that can read an NC code and the end > > result is the picture of the part? > > > > > > Thank You > > > > Colin Williams > > > > > > > > > > > > WABTEC CORPORATION CONFIDENTIALITY NOTE > > The content contained in this e-mail transmission is legally privileged > > and confidential information intended only for the use of the individual > > or entity named herein. If the reader of this transmission is not the > > intended recipient, you are hereby notified that any dissemination, > > distribution, or copying of this transmission is strictly prohibited. > > > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== Regards Alan Gordon Christchurch New Zealand ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
