Re: [mfg-smartcam] code

[Dave Hayden]

If you have a fairly large budget, there is always Vericut by CG Tech.
**********





"Jason Titcomb" <[EMAIL PROTECTED]> on 08/04/2000 07:36:52 AM

To:   "Williams, Colin" <[EMAIL PROTECTED]>, "Smartcam Forum"
      <[EMAIL PROTECTED]>
cc:    (bcc: Dave Hayden/elliott)
Subject:  Re: [mfg-smartcam] code




www.cncedit.com
  ----- Original Message -----
  From: Williams, Colin
  To: Smartcam Forum
  Sent: Thursday, August 03, 2000 4:03 PM
  Subject: [mfg-smartcam] code


  What is the name of the software that can read an NC code and the end
result is the picture of the part?


  Thank You

  Colin Williams





  WABTEC CORPORATION CONFIDENTIALITY NOTE
  The content contained in this e-mail transmission is legally privileged
and confidential information intended only for the use of the individual or
entity named herein. If the reader of this transmission is not the intended
recipient, you are hereby notified that any dissemination, distribution, or
copying of this transmission is strictly prohibited.

www.cncedit.com ----- Original Message ----- From: Williams, Colin To: Smartcam Forum Sent: Thursday, August 03, 2000 4:03 PM Subject: [mfg-smartcam] code What is the name of the software that can read an NC code and the end result is the picture of the part?     Thank You   Colin Williams     WABTEC CORPORATION CONFIDENTIALITY NOTE The content contained in this e-mail transmission is legally privileged and confidential information intended only for the use of the individual or entity named herein. If the reader of this transmission is not the intended recipient, you are hereby notified that any dissemination, distribution, or copying of this transmission is strictly prohibited.