Check out a product called Metacut View. It can be found at: http://www.services4automation.com/Mastercam/metacut_view.htm
Stephen Biehl Services Four Automation, LLC [EMAIL PROTECTED] www.services4automation.com -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Dave Hayden Sent: Friday, August 04, 2000 10:58 AM To: Jason Titcomb Cc: Williams, Colin; Smartcam Forum Subject: Re: [mfg-smartcam] code If you have a fairly large budget, there is always Vericut by CG Tech. ********** "Jason Titcomb" <[EMAIL PROTECTED]> on 08/04/2000 07:36:52 AM To: "Williams, Colin" <[EMAIL PROTECTED]>, "Smartcam Forum" <[EMAIL PROTECTED]> cc: (bcc: Dave Hayden/elliott) Subject: Re: [mfg-smartcam] code www.cncedit.com ----- Original Message ----- From: Williams, Colin To: Smartcam Forum Sent: Thursday, August 03, 2000 4:03 PM Subject: [mfg-smartcam] code What is the name of the software that can read an NC code and the end result is the picture of the part? Thank You Colin Williams WABTEC CORPORATION CONFIDENTIALITY NOTE The content contained in this e-mail transmission is legally privileged and confidential information intended only for the use of the individual or entity named herein. If the reader of this transmission is not the intended recipient, you are hereby notified that any dissemination, distribution, or copying of this transmission is strictly prohibited. ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
