RE: [mfg-smartcam] 4th Axis Code Output

[Joe Geraci]

Jon,   Your C/G need to be setup for wrapped geometry , check out the supplied C/G's that start with MW_xxxxx for examples   J.G. -----Original Message----- From: Jon Baker [mailto:[EMAIL PROTECTED]] Sent: Thursday, June 01, 2000 11:32 AM To: smartcam message board Subject: [mfg-smartcam] 4th Axis Code Output Ok folks, here is one that I am confused on.     I am trying to make a part that has radial notches around it, (see attached .pm4 file), and it looks good in smartcam, but my code generator refuses to output the angle information for milling around the part.  Is there a special section or trick to forcing that output????  Please help, I am supposed to be making these this week.  Thanks millions Jon