|
THANKS TO ALL. ! ! ! You folks are
great at providing me the simple answer to what I figure is hard to
comprehend. I am grateful to you all
Jon
----- Original Message -----
Sent: Thursday, June 01, 2000 9:03
AM
Subject: RE: [mfg-smartcam] 4th Axis Code
Output
Jon,
Your
C/G need to be setup for wrapped geometry , check out the supplied C/G's that
start with MW_xxxxx for examples
J.G.
Ok folks, here is one that I am confused
on.
I am trying to make a part
that has radial notches around it, (see attached .pm4 file), and it looks
good in smartcam, but my code generator refuses to output the angle
information for milling around the part. Is there a special section or
trick to forcing that output???? Please help, I am supposed to be
making these this week.
Thanks millions
Jon
|
