Re: [mfg-smartcam] 4th Axis Code Output

[Brian Nelson]

Can't provide an answer without a look at your code generation file. ----- Original Message ----- From: Jon Baker To: smartcam message board Sent: Thursday, June 01, 2000 10:31 AM Subject: [mfg-smartcam] 4th Axis Code Output Ok folks, here is one that I am confused on.     I am trying to make a part that has radial notches around it, (see attached .pm4 file), and it looks good in smartcam, but my code generator refuses to output the angle information for milling around the part.  Is there a special section or trick to forcing that output????  Please help, I am supposed to be making these this week.  Thanks millions Jon