Thanks, I will check each of these points Wed am, some have already been tested and gave no relief. Michael
D G Bowen wrote: > > Michael, > > I've not experienced the extreme problem you seem to be having. > > I have a few suggestions, but don't know if they'll work: > > Check your Utility, Surface Modes. I think that the Virtual Mesh Tolerance > and Point Set Fitting values have some effect on the output from the SMM > > Check the Intol and Outtol settings in Surface Machine. Set them to a really > large number, like .500 to see if the problem goes away. > > Try grouping only a few surfaces to machine at one time. > > Try Surface Machining with a very large stepover. See if that stops the > error. > > The problem may be due to the number of points generated by the SMM, not the > number of surfaces involved. > > If any of these things help, then we may be able to figure where to go from > here. > > Gene Bowen > > > I have increased incrementally as far as 200,000. > > OS is WinMillenium on a Athlon Thunderbird 900mhz. > > Michael -- Michael Gailey Visit our CAD/CAM/CNC Programming and 3D modeling website http://www.microsystemsgeorgia.com/toc.htm mailto:[EMAIL PROTECTED] ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
