[mfg-smartcam] using G52 or G92

[Jon Baker]

Hi gang,     I have a part I am working on making more productive, the part is small, 1/8 x 13/16 x 1 1/4 long and I am going to run it in two 4" double lock vises.  The rear station will hold two parts, one out each side, and the front station the same.  This will make 8 parts for two vises.     This is a repeat job, and I plan on running it often.  The two vises are mounted on an aluminum plate, which is bolted to the table.  There is a tooling hole at dead center of the plate, and I have the vises all laid out in layers.     I currently have each part identified as a new fixture offset, G54, G55, etc., but I want to just have one fixture offset, at the tooling hole, and have G52 or G92 location shifts for each part zero.     So, how do I do this?  What does a tmp file look like that will do this, and allow me to jump from part to part to part, countersinking the one hole in each.         Thanks for your input. Jon