--- Begin Message --- Hi gang,
This is a repeat job, and I plan on running it often. The two vises are
mounted on an aluminum plate, which is bolted to the table. There is a
tooling hole at dead center of the plate, and I have the vises all laid out
in layers.
I currently have each part identified as a new fixture offset, G54, G55,
etc., but I want to just have one fixture offset, at the tooling hole, and
have G52 or G92 location shifts for each part zero.
Thanks for your input.
Jon
I would look into G10, you don't need to do anything with SmartCam just load
the G10 offsets into the program.
Google Search G10
Tom --- End Message ---
