Try this... G52 X#XFO Y#YFO Z#ZFO
============================================= Fred Lauzus, CAM Programming Coordinator High Steel Structures, Incorporated mailto:[EMAIL PROTECTED] http://www.highsteel.com ============================================= -----Original Message----- From: Jon Baker [mailto:[EMAIL PROTECTED]] Sent: Monday, July 02, 2001 7:28 PM To: SmartCam User Group Subject: [mfg-smartcam] using G52 or G92 Hi gang, I have a part I am working on making more productive, the part is small, 1/8 x 13/16 x 1 1/4 long and I am going to run it in two 4" double lock vises. The rear station will hold two parts, one out each side, and the front station the same. This will make 8 parts for two vises. This is a repeat job, and I plan on running it often. The two vises are mounted on an aluminum plate, which is bolted to the table. There is a tooling hole at dead center of the plate, and I have the vises all laid out in layers. I currently have each part identified as a new fixture offset, G54, G55, etc., but I want to just have one fixture offset, at the tooling hole, and have G52 or G92 location shifts for each part zero. So, how do I do this? What does a tmp file look like that will do this, and allow me to jump from part to part to part, countersinking the one hole in each. Thanks for your input. Jon ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
