Re: [mfg-smartcam] DNC Software

[Greg Morgan]

Title: Untitled Stationery

We use CrossTalk, that is a very old program, but enables communication to take place without any problems once everything is setup.  We had a tech make sure the wiring was correct and we had the basic information for each control.  Once we got the first one working we were able to get the rest setup in notime.  The first took about two hours.  This software is very inexpensive and works well with our equipment, Mazak's, and Ikegai's.

Greg King wrote:

    We computers on the floor at each machine or in a central location connected to a NT network. The computers have software called PC-DNC ( www.sub-soft.com )that the operators use to transfer the programs to the machine tool. We are able to update program on the fly and maintain the library of program from any system on the network.

 

Greg King
Group Leader
Manufacturing Services

      Rittal Corporation
        Phone: 937-629-2485
        Fax:      937-390-8383

-----Original Message-----
From: Williams, Colin [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, November 27, 2001 12:26 PM
To: Smartcam Forum (E-mail)
Subject: [mfg-smartcam] DNC Software

Is there a DNC software that can allow you to send or receive programs from your computer, instead of going out to the machines in the plant to do the same.

 

Thank you

 

 

Colin Williams



WABTEC CORPORATION CONFIDENTIALITY NOTE
The content contained in this e-mail transmission is legally privileged and confidential information intended only for the use of the individual or entity named herein. If the reader of this transmission is not the intended recipient, you are hereby notified that any dissemination, distribution, or copying of this transmission is strictly prohibited.


-- 
Thank you,

Greg Morgan

C N C Industries Inc.,
1413 Beech Lane
P.O. Box 1667
Fairmont, WV 26555-1667
Phone 304 366 8262
Fax 304 367 0218
E-mail [EMAIL PROTECTED]
Web Page www.cncindust.com