|
Hey guys, not
sure if you heard about this one, but it is an incredibly bad virus. The
virus is attached to an e-mail message (in subject it says "hi") and the file is
called GONE.SCR. Because it is a screensaver, it typically will not be
caught by your mainframe's virus detector. DO NOT open this file. It
will immediately attack you e-mail address book and start sending messages (20
to each person). Eventually, it will start to attack your executable
files.
In case you think
this is a hoax, check any virus detector website (McAfee, etc). We had it
sweep through our company yesterday and it infected four computers that opened
the file and two of those sent out messages to everyone in their personal e-mail
address book and all contacts. It is not the e-mail itself that
is infected, but the file attached. Just to be safe, please delete
any files that resemble this. Again, I promise you, this is
not hoax. I saw the damage for myself.
Our MIS was able
to clean the infected computers, so it is possible to clean your
computer from it. Thanks for listening... Please, if you don't
believe me, check.
Regards-
Cami L. Richter
Engineering Technician
San Jamar
(262) 723-6133
x121
(262) 723-4204 (fax)
[EMAIL PROTECTED]
I have been coding tool center in
the past because I have't been running much in the way of mass
production, the machine is more predictable and I get less cutter comp
interferance alarms. I am now ready to try using more cutter comp
programming so I can code once and adjust for reground cutters in the tool
diameter setting.
This group is great! I didn't
realize how much help was available.
Thanks to everyone!
Vance, Q&E,
Inc.
----- Original Message -----
Sent: Tuesday, December 04, 2001 7:49
PM
Subject: Re: [mfg-smartcam] Cutter
comp
Vance,
Is this a particular scenario, for turning the
cutter comp on early, or routine programming.....
Just wondering,
because the Haas control seems to have pretty generic (good) behavior. when
it comes to cutter comp. Outside of Bridgeport and maybe some early
Dynapath controls, I don't recall much need for cutter comp
tricks.....( turning on before 'Z' approach') based on centerline
programming, as suggested earlier...
You should be able to plunge a
point in the pocket and feed to the profile (turning comp on) as long as
that point is more than half the diameter of the tool away from the
profile. Usually if a profile is cramped for space, I will put a " no
positive comp allowed" in my instructions, and all should fly...
Most
cutter comp needs should be handled, in my opinion, with the template
file. Let us know if this is a special situation, or, if you normally
code "part profile" vs " tool center", which definitely would make most
machine controls less tame, in my opinion... (Ex: inputting .+498" vs -.002"
as comp. for a 1/2 end mill)
Thanks,
Mark
How can I get SmartCam 11.5 Production
Milling to output code with cutter comp to initiate before the first move
in Z before starting a profile. For example; entering a pocket which
is not much bigger than the diameter of the end mill.
(Using a
Haas VF-0 vertical machining center) Can I do this in Machine define, or
is there an edit in the .tmp file I can
make?
**********************************************************************
This email and any files transmitted with it are confidential and
intended solely for the use of the individual or entity to whom they
are addressed. If you have received this email in error please notify
the system manager.
This footnote also confirms that this email message has been swept by
MIMEsweeper for the presence of computer viruses.
www.mimesweeper.com
**********************************************************************
|
